nXe8002 2-Channel Networkable Multi-Mode Power Amplifier; Maximum Rated Output Power Shall Be 800W Per Channel at Low Z, 70V, and 100V Mode; Euroblock Input Connectors

nXe8002 2-Channel Networkable Multi-Mode Power Amplifier; Maximum Rated Output Power Shall Be 800W Per Channel at Low Z, 70V, and 100V Mode; Euroblock Input Connectors KEY FEATURES - Maximum Rated Output Power Shall Be 800W Per Channel at Low Z, 70V, and 100V Mode - Ethernet Control and monitoring of amplifier functions, with front panel COM activity LED - Serial data port for use with Ashly remote control devices - Real-Time Clock with Event Scheduler - Programmable power-on delay - Aux preamp outputs, and fault condition logic outputs - Rear panel DIP switches select low impedance (2, 4, and 8 Ohm), constant voltage (70V or 100V), high pass filter, limiter and input gain on each channel - Energy Management System (EMS) for increased efficiency) automatic <1Wsleep-mode (defeatable) - Switch mode power supply automatically detects 120V or 240V AC operation - Extensive protection circuitry - Continuously variable cooling fans - Euroblock input connectors & Euroblock loudspeaker connectors - Front panel power switch and level controls - Multiple internal power supplies provide increased channel separation and reliability - Safety / Compliance: cTUVus, CE, FCC, RoHS SPECIFICATIONS - Voltage Gain: Selectable at 26dB, 32dB, 38dB, or 1.4V - Damping Factor: >250 (8 Ohm load <1kHz) - Input High Pass Filter: 80Hz 2nd order - Distortion (SMPTE): <0.5% - Distortion (THD-N): <0.5% (8 Ohms, 10dB below rated power, 20Hz–20kHz) - Channel Separation: -75dB (dB from full output, 1kHz) - Signal-to-Noise (unweighted) 20Hz-20kHz, Gain@26dB: >108dB - Frequency Response: 20Hz-20kHz, +/-0.05dB - Input Impedance: 10k Ohms - Maximum Input Level: +21dBu - AUX Output Maximum Level: +21dBu - Nominal Voltage Input: 100 – 240VAC - Operating Range: 70 – 270VAC - Dimensions: 19"L x 3.5"H x 16.84"D - Weight: 22.2lbs

• Ethernet Control and monitoring of amplifier functions, with front panel COM activity LED
• Use Protea Software to remotely disable all front panel controls, including the on/off switch, for a tamper-proof installation
• Instant Standby Mode 30% reduction in power consumption with on/off and Preset Recall, both via contact closure, software control, or event scheduler
• Energy Management System (EMS) for increased efficiency) automatic <1Wsleep-mode (defeatable)
• Multiple internal power supplies provide increased channel separation and reliability